Camry Coupe 2-Door V6-3.0L (1MZ-FE) (1996)
Impact Sensor: Service and Repair
Center Airbag Sensor
CENTER AIRBAG SENSOR ASSEMBLY REMOVAL AND INSTALLATION
NOTICE:
-
Do not open the cover or the case of the ECU and various computers unless absolutely necessary. (If the IC terminals are touched, the IC may be
destroyed by static electricity.)
-
Never use SRS parts from another vehicle. When replacing parts, replace with new parts.
-
Never reuse the center airbag sensor assembly Involved in a collision when the airbag has deployed.
-
Never repair a sensor in order to reuse it.
1. Remove these parts.
-
Front door inside scuff plate
-
Front door opening cover
-
Cowl side trim
-
Coin box
-
Coin box bezel
-
Lower center cover
-
Lower No.2 cover
-
Lower finish panel
-
Console upper panel
-
Rear console box
-
Front console box
2. Remove and install center airbag sensor assembly.