Camry LE Sedan L4-2164cc 2.2L DOHC (5S-FE) MFI (2000)
![background image](/toyota/camry_le_sedan/l4-2164cc_2.2l_dohc_(5s-fe)_mfi/Page-1049007.png)
a. Remove the 3 bolts, end cover, gasket and plunger.
b. Using vernier calipers, measure the contact plate for depth of wear.
Maximum wear: 0.9 mm (0.035 in.)
If the depth of wear is greater than the maximum, replace the contact plate.
c. Remove the terminal kit parts.
1. Using SST, loosen the terminal nuts.
SST 09810-38140
2. Terminal C:
Remove the terminal nut, wave washer, terminal insulator (outside), 0-ring, terminal bolt, contact plate and terminal insulator (inside).
3. Terminal 30:
Remove the terminal nut, wave washer, terminal insulator (outside), packing, 0-ring, terminal bolt, contact plate, terminal insulator (inside).
d. Temporarily install these new terminal 30 kit parts:
1. Terminal insulator (inside)