Camry LE Sedan L4-2164cc 2.2L DOHC (5S-FE) MFI (2000)
c. Recheck the total preload.
Preload (turning): 0.8 - 1.4 Nm (8 - 14 kgf.cm, 6.9 - 12.2 inch lbs.)
d. Remove the RH and LH rack ends.
17. INSTALL RH AND LH CLAW WASHERS AND RACK ENDS
a. Install a new claw washer, and temporarily install the rack end.
HINT: Align the claws of the washer with the steering rack grooves.
b. Using a spanner (24 mm) to hold the steering rack steady, and using SST, torque the rack end.
SST 09922-10010
Torque: 60 Nm (615 kgf.cm, 45 ft. lbs.)
NOTICE: Use SST 09922-10010 in the direction shown in the illustration.
HINT: Use a torque wrench with a fulcrum length of 345 mm (13.58 inch).
c. Using a brass bar and hammer, stake the washer.
NOTICE: Avoid any impact to the rack.
18. INSTALL RH AND LH RACK BOOTS, CLAMPS AND CLIPS