Camry LE Sedan V6-3.0L (1MZ-FE) (1998)
Hydraulic Assembly: Service and Repair
REMOVAL
1. Remove right front fender liner.
2. Remove A/C tube clamp bracket bolt.
3. Disconnect brake lines.
Using Special Service Tool (SST) 09751-36011 or equivalent, disconnect the 6 brake lines from the ABS & TRAC actuator.
Torque:
-
10 mm nut 15 Nm (11 ft. lbs.)
-
12 mm nut 20 Nm (14 ft. lbs.)
4. Remove ABS & TRAC actuator assembly.
a. Disconnect the 2 connectors.
b. Remove the 2 bolts, 2 nuts and ABS & TRAC actuator assembly.
Torque: 19 Nm (14 ft. lbs.)
5. Remove ABS & TRAC actuator.
a. Remove the 2 nuts and ABS & TRAC actuator from actuator bracket.
Torque: 5.4 Nm (48 inch lbs.)
b. Remove the 2 holders and 3 cushions from the ABS & TRAC actuator.
INSTALLATION
Installation is in the reverse order of removal.
1. After installation, fill brake reservoir with brake fluid and bleed brake system.
2. Check for leaks.