Camry LE Sedan V6-3.0L (1MZ-FE) (1998)
b. Apply the packing on the expansion valve.
NOTE: Do not overtape the packing beyond the expansion valve edge.
3. INSTALL EXPANSION VALVE
a. Install the expansion valve with the 2 bolts.
Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)
NOTE: When installing the expansion valve, take care so that the packing is not jammed with the evaporator.
HINT: Lubricate 2 new O-rings with compressor oil and install O-rings on the expansion valve.
b. Peel off the remaining packing paper and apply the packing to expansion valve.
4. INSTALL THESE PARTS:
a. Blower unit
b. Glove compartment
5. CONNECT LIQUID TUBE AND SUCTION TUBE
Torque:
Liquid tube: 14 N.m (140 kgf.cm, 10 ft.lbf)
Suction tube: 32 N.m (330 kgf.cm, 24 ft.lbf)
HINT: Lubricate 2 new O-rings with compressor oil and install the tubes.
6. EVACUATE AIR FROM REFRIGERATION SYSTEM AND CHARGE SYSTEM WITH REFRIGERANT
Specified amount: 800 ± 50 g (28.22 ± 1.76 oz.)
7. INSPECT FOR LEAKAGE OF REFRIGERANT
Using a gas leak detector, check for leakage of refrigerant. If there is leakage, check the tightening torque at the joints.