Camry LE Sedan V6-3.0L (1MZ-FE) (1998)
Alignment: Service and Repair
Rear
INSPECTION
1. Measure vehicle height.
Tire size: P205/65R15
a. Front measuring point; measure from the ground to the center of the front side lower suspension arm mounting bolt.
Front height: 215 mm (8.46 inch)
b. Rear measuring point; measure from the ground to the center of the front side strut rod mounting bolt.
Rear height: 266 mm (10.49 inch)
NOTE:
-
Before inspecting the wheel alignment, adjust the vehicle height to the specification.
-
If the vehicle height is not to the specification, try to adjust it by pushing down on or lifting the body.
2. Install camber-caster-kingpin gauge onto vehicle or position vehicle on wheel alignment tester.
NOTE: Follow the specific instructions on the equipment manufacturer.
3. Inspect Camber.
Camber: -0° 45' ± 45' (-0.75° ± 0.75)
Left-right error: 45' (0.75°) or less
CAUTION: Camber is not adjustable, if the measurements are not within the specification, inspect the suspension parts for damaged and/or
worn-out parts and replace them as necessary.
Measuring Point Reference
4. Inspect Toe-In.