Camry Sedan L4-2.0L (3S-FE) (1987)
Water Pump: Service and Repair
Fig. 17 Water Pump Removal.
1.
Disconnect battery ground cable, then the coolant temperature switch connector.
2.
Disconnect lower radiator hose from coolant inlet housing.
3.
Remove timing belt and sprockets. Refer to TIMING BELT for procedure.
Fig. 18 Water Pump Bolt Tightening Sequence
REMOVE WATER PUMP AND WATER PUMP COVER ASSEMBLY
Remove water bypass tubes to water pump cover attaching bolts, then the three water pump attaching bolts.
(a) Remove the two nuts holding the pump to the water by-pass pipe.
(b) Remove the three bolts in the sequence shown.
(c) Pull out the water pump together with pump cover.
(d) Remove the two 0-rings and gasket.
DISASSEMBLE WATER PUMP AND WATER PUMP COVER
Remove the three bolts, water pump and gasket from the pump cover.