Camry Sedan L4-2.0L (3S-FE) (1987)
Fuel Pressure: Testing and Inspection
FUEL PRESSURE INSPECTION
(a) Check the battery voltage above 12 volts.
(b) Disconnect the cable from the negative (-) terminal of the battery.
(c) Disconnect the cold start injector connector.
(d) Put a suitable container or shop towel under the cold start injector pipe.
(e) Remove the two union bolts, four gaskets and cold start injector pipe.
NOTE: Slowly loosen the union bolt.
(f) Install SST (pressure gauge) to the delivery pipe with new two gaskets and union bolt.
SST 09268-45011
Torque: 180 kg-cm (13 ft-lb, 18 Nm)
(g) Wipe off any splattered gasoline.
(h) Reconnect the battery negative (-) cable.
(i) Using a service wire, short terminals +B and FP of the check connector.
(j) Turn the ignition switch ON.