Camry Sedan L4-2.0L (3S-FE) (1987)
Axle Shaft: Service and Repair
Center Driveshaft
The following procedure applies only to right hand driveshaft on 1985-88 Camry with gasoline engine.
1.
Using suitable tools, press out dust covers.
2.
Remove snap ring.
3.
Using tool 09950-00020 or equivalent, remove bearing.
4.
Remove the snap ring.
5.
Install snap ring over shaft, then, using tool 09527-20011 or equivalent, press on a new bearing.
6.
Install new snap ring.
7.
Using suitable press, press in a new dust cover on driveshaft side to a clearance of 0.04-0.08 inch, ensuring that there is clearance between dust
cover and bearing.
8.
Using suitable press, press in a new dust cover on transaxle side to a distance of 3.39-3.43 inches from end of shaft.