Camry Sedan L4-2.4L (2AZ-FE) (2003)
a. Install the bolt and crankshaft position sensor.
Torque: 9.0 Nm (92 kgf-cm, 80 inch lbs.)
b. Confirm the wire harness of the crank position sensor is placed as shown in the illustration.
48. INSTALL CRANKSHAFT PULLEY
a. Install the crankshaft pulley (TMC made).
1. Align the pulley set key with the key groove of the pulley, and side on the pulley.
SST 09213-54015 (91651-60855), 09330-00021
2. Using SST, install the pulley bolt.
Torque: 170 Nm (1,733 kgf-cm, 125 ft. lbs.)
b. Install the crankshaft pulley (TMMK made).
1. Align the pulley set key with the key groove of the pulley, and side on the pulley.
SST 09960-10010 (09962-01000, 09963-01000)
2. Using SST, install the pulley bolt.
Torque: 170 Nm (1,733 kgf-cm, 125 ft. lbs.)
c. Turn the crankshaft counterclockwise, and disconnect the plunger knock pin from the hook.
d. Turn the crankshaft clockwise, and check that the slipper is pushed by the plunger.
49. INSTALL CYLINDER HEAD COVER SUB-ASSY
50. INSTALL IGNITION COIL ASSY
Torque: 9.0 Nm (92 kg1-cm, 80 inch lbs.)
51. INSTALL VANE PUMP ASSY