Camry Sedan L4-2.4L (2AZ-FE) (2003)
NOTICE: When installing the tensioner, set the hook again if the hook releases the plunger.
3. Turn the crankshaft counterclockwise, and disconnect the plunger knock pin from the hook.
4. Turn the crankshaft clockwise, and check that the slipper is pushed by the plunger.
12. INSTALL CYLINDER HEAD COVER SUB-ASSY
a. Remove any old packing (FIPG) material.
b. Apply seal packing to 2 locations as shown in the illustration.
Seal packing: Part No. 08826-00080 or equivalent
NOTICE:
-
Remove any oil the contact surface.
-
Install the cylinder head cover within 5 minutes after applying seal packing.
-
Do not put into engine oil 2 hours after installing.
c. Install the cylinder head cover with the 8 bolts and 2 nuts.
Torque: 11 Nm (110 kgf-cm, 8 ft. lbs.)
13. INSTALL IGNITION COIL ASSY
Torque: 9.0 Nm (92 kgf-cm, 80 inch lbs.)
14. INSTALL FRONT WHEEL RH
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
15. INSPECT OIL LEAK