Camry Sedan L4-2.4L (2AZ-FE) (2003)
b. Using an ohmmeter, check the continuity between terminals F and E.
Standard: When the positive and negative poles between terminals F and E are exchanged, there is continuity in one way but no continuity in
another way.
If the continuity is not as specified, replace the voltage regulator.
8. INSPECT GENERATOR ROTOR ASSY
a. Inspect rotor for open circuit.
1. Using an ohmmeter, check that there is continuity between the slip rings.
Standard resistance: 2.7 - 3.1 ohms at 20 °C (68 °F)
If there is no continuity, replace the rotor
b. Inspect rotor for ground.
1. Using an ohmmeter, check that there is no continuity between the slip ring and rotor.
If there is continuity, replace the rotor.