Camry Sedan L4-2.4L (2AZ-FE) (2003)
15. INSTALL GENERATOR BRUSH HOLDER ASSY
a. Install the 2 screws and brush holder.
Torque: 2.0 N.m (20 kgf.cm, 18 in.lbf)
NOTE: Be careful of the holder installation direction.
b. Install the brush cover.
c. Install the end cover and plate terminal with the bolt and 3 nuts.
Torque:
Nut 4.4 N.m (45 kgf.cm, 39 in.lbf)
Bolt 3.9 N.m (39 kgf.cm, 35 in. lbf)
d. Install the terminal insulator with the nut.
Torque: 4.1 N.m (42 kgf.cm, 36 in.lbf)
16. INSTALL GENERATOR PULLEY
SST 09820 - 63010 (09820 - 06010, 09820 - 06020)
a. Install the pulley to the rotor shaft by tightening the pulley nut by hand.
b. Hold SST 1 - A with a torque wrench, and tighten SST 1 - B clockwise to the specified to torque.
Torque: 39 N.m (400 kgf.cm, 29 ft.lbf)
NOTE: Check that SST is secured to the pulley shaft.