Camry Sedan V6-180.5 2959cc 3.0L DOHC (3VZ-FE) (1992)
Cruise Control Switch: Service and Repair
Service
Fig. 7 Combination Switch Assembly. 1992,93 Camry
1.
Remove wire harness cover attaching screws, pry loose two locking lugs, then remove cover, Fig. 7.
2.
Open terminal cover, then from open end, install suitable small screwdriver between locking lug and terminal, pry down on locking lug and pull
terminal out from rear.
3.
Remove spiral cable four attaching screws, disconnect electrical connector, then remove spiral cable.
4.
Remove light control switch attaching screws and ball set plate, then remove ball and slide switch and spring from body.
5.
Remove headlamp dimmer and turn signal switch.
6.
Remove wiper and washer switch.
7.
Reverse procedure to install.