Camry Sedan V6-180.5 2959cc 3.0L DOHC (3VZ-FE) (1992)
3. INSTALL SNAP RING
a. Select a snap ring that will allow minimum axial play.
b. Using a snap ring expander, install the snap ring.
4. MEASURE FIRST GEAR THRUST CLEARANCE
Using a feeler gauge, measure the 1st gear thrust clearance.
Standard clearance: 0.10 - 0.35 mm (0.0039 - 0.0138 in.)
5. INSTALL SPACER, NEEDLE ROLLER BEARING, SYNCHRONIZER RINGS, SECOND GEAR AND THIRD DRIVEN GEAR
a. Install the spacer.
b. Apply MP grease to the needle roller bearing.
c. Place the synchronizer rings (for 2nd gear) on the gear.
NOTE: Do not install the synchronizer ring for 1st gear.