Camry Sedan 2-Door V6-3.0L (1MZ-FE) (1994)
EGR Temperature Sensor: Service and Repair
Removal
PROCEDURE
Removal
1. Disconnect Negative (-) Terminal Cable From Battery.
CAUTION: Work must be started after 90 seconds from the time the ignition switch is turned to the LOCK position and the negative (-) terminal
cable is disconnected from the battery.
2. Remove No.2 Exhaust Gas Recirculation (EGR) pipe; remove the 4 nuts, EGR pipe and 2 gaskets.
3. Disconnect the EGR Gas Temperature Sensor connector and clamp.
4. Remove EGR Valve and Vacuum Modulator assembly.
^
Disconnect the following hoses:
Vacuum hose from port P of EGR Vacuum Modulator. (1)
Vacuum hose from port Q of EGR Vacuum Modulator. (2)
Vacuum hose from port R of EGR Vacuum Modulator. (3)
Vacuum hose from EGR Valve. (4)