Camry Sedan 2-Door V6-3.0L (1MZ-FE) (1994)
Knock Sensor: Service and Repair
Installation
PROCEDURE
1. Reinstall Knock Sensors and connect the Knock Sensor connectors.
Torque: 39 Nm (29 ft lb)
2. Reinstall water outlet and right hand engine mounting stay.
^
Install 2 new gaskets on the cylinder head.
^
Install the water outlet with the the 2 bolts, 2 plate washers and 2 nuts.
Torque: 15 Nm (11 ft lb)
NOTE: Do not scratch the seal surface of the water outlet with the stud bolt.
^
Connect the water bypass hose to the inlet housing.
^
Install the wire band.
^
Install the right hand mounting stay with the 3 bolts.
Torque: 31.4 Nm (23 ft lb)
^
Connect the following hoses and connectors:
-
Radiator inlet hose. (1)
-
Engine coolant reservoir hose. (2)
-
Engine Coolant Temperature Sensor connector. (3)
-
Engine Coolant Temperature Switch connector. (4)
-
Ground strap connector. (5)