Camry Sedan 4-Door L4-132 2164cc 2.2L DOHC (5S-FE) (1995)
Rear brake fluid pressure:
HINT:
-
Depress the brake pedal while the engine is running.
-
The brake pedal should not be depressed twice and/or returned while setting to the specified pressure. Read the value of rear pressure 2
seconds after adjusting to the specified fluid pressure.
4. IF NECESSARY. ADJUST FLUID PRESSURE
a. Set the shaft length A to initial set length and tighten the adjusting bolt lock nut.
Initial set length: 26.0 mm 1.02 in.
b. Check the rear brake fluid pressure.
c. If not within specification, adjust the fluid pressure by changing the shaft length.
Low pressure - Lengthen A High pressure - Shorten A
HINT: For every full turn of the adjusting nut, the fluid pressure will change as follows:
Fluid Pressure change
d. Torque the lock nut.
TORQUE: 13 Nm 130 kgf.cm, 9 ft.lb
If it cannot be adjusted, replace the valve body.