Camry Sedan 4-Door L4-132 2164cc 2.2L DOHC (5S-FE) (1995)
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
REMOVAL
1. DISCONNECT NEGATIVE(-) TERMINAL CABLE FROM BATTERY.
CAUTION: Work must not be started for at least 90 seconds from the time the ignition switch is turned to the LOCK position and the negative (-)
terminal cable is disconnected from the battery.
2. DRAIN ENGINE COOLANT.
3. REMOVE ENGINE COOLANT TEMPERATURE (ECT) SENSOR.
-
Disconnect the ECT Sensor connector.
-
Using a deep socket wrench. remove the ECT Sensor and gasket.
INSTALLATION
1. INSTALL A NEW GASKET TO THE ECT SENSOR.
2. USING A DEEP SOCKET, INSTALL THE ECT SENSOR.
Torque: 20 Nm (14 ft.lb)
3. CONNECT THE ECT SENSOR CONNECTOR.
4. REFILL ENGINE WITH COOLANT.
5. RECONNECT NEGATIVE(-) TERMINAL CABLE TO BATTERY.