Camry Sedan 4-Door L4-132 2164cc 2.2L DOHC (5S-FE) (1995)
e. Turn the intake camshaft clockwise or counterclockwise little by little until the exhaust camshaft sits in the bearing journals evenly without
rocking the camshaft on the bearing journals.
NOTE: It is very important to replace the camshaft in the bearing journals evenly while tightening bearing caps in the subsequent steps.
f.
Install the bearing caps in their proper locations.
g. Apply a light coat of engine oil on the threads and under the heads of the bearing cap bolts.
h. Install and uniformly tighten the ten bearing cap bolts in several passes. in the sequence shown.
Torque: 19 Nm (14 ft lb)
i.
Remove the service bolt (B).
3. Check and adjust valve clearance.
Turn the camshaft and position the cam lobe upward, and check and adjust the valve clearance.
Valve clearance (Cold):
Intake: 0.19 - 0.29 mm (0.007 - 0.011 in.)
Exhaust: 0.28 - 0.38 mm (0.011 - 0.015 in.)
If clearance not within specifications adjust valve clearance.
4. Install semi-circular plugs.