Camry Sedan 4-Door L4-132 2164cc 2.2L DOHC (5S-FE) (1995)
Ignition Cable: Testing and Inspection
Federal Vehicles
INSPECTION PROCEDURE
1. DISCONNECT HIGH-TENSION CORDS FROM SPARK PLUGS.
NOTE: Disconnect the high - tension cords at the rubber boot. DO NOT pull on the cords. Pulling on or bending the cords may damage the
conductor Inside.
2. DISCONNECT HIGH-TENSION CORDS FROM DISTRIBUTOR CAP.
3. INSPECT HIGH-TENSION CORD RESISTANCE.
-
Using an ohmmeter measure the resistance.
Maximum resistance: 25 k ohms per cord
-
If the resistance is greater than maximum, check the terminals.
-
If necessary, replace the high - tension cord.
4. RECONNECT HIGH-TENSION CORDS TO DISTRIBUTOR CAP.
5. RECONNECT HIGH-TENSION CORDS TO SPARK PLUGS.