Camry Sedan 4-Door L4-132 2164cc 2.2L DOHC (5S-FE) (1995)
Camshaft Position Sensor: Component Tests and General Diagnostics
California Spec. Vehicles
Procedure
1. INSPECT AIR GAP.
-
Using the SST, measure the air gap between the signal rotor and the G1 and G2 pickup coil projections. (SST 09240-00020 for G1 and G2
pickups).
Air gap: 0.2 - 0.5 mm (0.008 - 0.020 in)
-
If the air gap is not as specified, replace the distributor housing assembly.
2. DISCONNECT DISTRIBUTOR CONNECTOR.
3. INSPECT SENSOR RESISTANCE.
-
Using an ohmmeter, measure the resistance between terminals
G1; G2 and G(-).
Resistance {G1 or G2 to G(-)} (Cold): 125 - 200 Ohms
Resistance {G1 or G2 to G(-)} (Hot): 160 - 235 Ohms
NOTE: "Cold" and "Hot" in the preceding specs express the temperature of the coils themselves.
"Cold" is from -10°C (14°F) to 50°C (122°F)
"Hot" is from 50°C (122°F) to 100°C (212°F).
-
If the resistance is not as specified, replace the distributor housing assembly.
NOTE: For G signal circuit testing procedures, refer to DTC 12 and DTC 13 under the "Trouble Code Charts".
See: Computers and Control Systems/Testing and Inspection
Federal Spec. Vehicles