Camry Sedan 4-Door V6-3.0L (1MZ-FE) (1994)
Crankshaft Position Sensor: Service and Repair
PROCEDURE
Removal
1. Disconnect negative (-) terminal cable from battery.
CAUTION: Work must be started after 90 seconds from the time the Ignition switch Is turned to the LOCK position and the negative (-) terminal
cable is disconnected from the battery.
2. Remove right side engine under cover.
3. Remove right side fender apron seal.
4. Disconnect engine wire. Remove the 3 nuts and disconnect the engine wire.
5. Remove Crankshaft Position Sensor.
^
Remove the bolt and remove the Crankshaft Position Sensor.
^
Disconnect the Crankshaft Position Sensor connector.