Camry Sedan 4-Door V6-3.0L (1MZ-FE) (1994)
5. DISCONNECT STABILIZER BAR LINK FROM LOWER ARM
-
Remove the nut and disconnect the stabilizer bar link from lower arm.
6. DISCONNECT STEERING KNUCKLE FROM LOWER BALL JOINT
-
Remove the bolt and the 2 nuts.
-
Disconnect the steering knuckle from the lower ball joint.
7. LOOSEN 6 BOLTS HOLDING DRIVE SHAFT TO DIFFERENTIAL SIDE GEAR SHAFT OR CENTER DRIVE SHAFT
-
Place match marks on the drive shaft and side gear shaft or center drive shaft.
NOTICE: Do not use a punch to mark the matchmarks. Use paint, etc.
-
Using SST, loosen the 6 hexagon bolts while depressing the brake pedal.
SST 09923-00020
HINT: Do not remove the bolts, leave them finger tight to avoid drop ping the drive shaft.
8. DISCONNECT DRIVE SHAFT FROM AXLE HUB
-
Using a plastic hammer, disconnect the drive shaft from the axle hub.