Camry Sedan 4-Door V6-3.0L (1MZ-FE) (1994)
b. Using SST and a press, remove the 3rd driven gear and 2nd gear.
SST 09950-00020
c. Remove the needle roller bearing and synchronizer rings.
5. REMOVE NO.1 HUB SLEEVE ASSEMBLY, 1ST GEAR, SYNCHRONIZER RING, NEEDLE ROLLER BEARING, THRUST WASHER
AND LOCKING BALL
a. Using a press, remove the No.1 hub sleeve, 1st gear and synchronizer ring.
b. Remove the needle roller bearing and locking ball.
c. Using a screwdriver and hammer. drive out the thrust washer.
6. REMOVE NO.1 HUB SLEEVE, SHIFTING KEYS AND SPRINGS FROM NO.1 CLUTCH HUB
OUTPUT SHAFT COMPONENT PARTS INSPECTION