Camry Solara SE L4-2164cc 2.2L DOHC (5S-FE) MFI (2000)
_mfi/Page-897002.png)
c. Check to see that there is no remarkable play in the radial direction of the inboard joint.
d. Check the boots for damage.
2. REMOVE INBOARD AND OUTBOARD JOINT BOOT CLAMPS
a. Using pliers, pinch the claw A and B to compress the large inboard joint boot clamp and remove it.
b. Using a side cutter, cut the small inboard joint boot clamp and remove it.
c. Using a side cutter, cut the 2 outboard joint boot clamps and remove them.
3. REMOVE INBOARD JOINT SHAFT
a. Place matchmarks on the tripod, inboard and outboard joint shafts.
NOTICE: Do not punch the marks.
b. Remove the inboard joint shaft from the outboard joint shaft.
4. REMOVE TRIPOD
a. Using a snap ring expander, remove the inboard joint side snap ring.
b. Using a snap ring expander, temporarily slide the outboard joint side snap ring toward the outboard joint side.
c. Place matchmarks on the outboard joint shaft and tripod.
NOTICE: Do not punch the marks.
d. Using a brass bar and hammer, remove the tripod from the outboard joint shaft.
NOTICE: Do not tap the roller.
e. Using a snap ring expander, remove the snap ring.
5. REMOVE INBOARD AND OUTBOARD JOINT BOOTS
Slide out the 2 boots.
NOTICE: Do not disassemble the outboard joint.