Camry Solara SLEV6 V6-3.0L (1MZ-FE) (2000)
b. Insert the SST onto the torsion bar of the hinge side.
SST 0980-24010
c. Slowly lift the torsion bar with the SST and place it in the torsion bar bracket.
d. Slowly push the SST down and install the torsion bar to the hinge.
e. Slowly lift the SST and install the torsion bar.
f.
Install the torsion bar to the center bracket.
g. Repeat for the other side.
2. CHECK LUGGAGE DOOR LIFT
-
Pop-up distance: 35 - 100 mm
-
Pop-upto 2/3 open:
Door should remain in any position.
-
Past 2/3 open:
Door should open fully by itself.
-
Full open position:
Door should not easily fall closed.
If adjustment is necessary, refer to step 1-(a) above.
3. INSTALL UPPER BACK TRIM
a. Install the upper back trim.
b. Install the rear seat outer belts LH and RH with the 2 bolts.
Torque: 42 N.m (430 kgf.cm, 31 ft.lbf)