Camry Solara SLEV6 V6-3.0L (1MZ-FE) (2000)
HINT: Tape the screwdriver tip before use.
b. Remove the 2 pistons and springs by hand, pulling straight out, not at an angle.
NOTICE: If pulled out and installed at an angle, there is a possibility that the cylinder bore could be damaged.
INSPECTION
HINT: Clean the disassembled parts with compressed air.
1. INSPECT CYLINDER BORE FOR RUST OR SCORING
2. INSPECT CYLINDER FOR WEAR OR DAMAGE
If necessary, clean or replace the cylinder.
REASSEMBLY
NOTICE: Apply lithium soap base glycol grease to the rubber parts indicated by the arrows.
1. Except w/ TRAC: PLACE CYLINDER IN VISE
2. Except w/ TRAC: INSTALL 2 PISTON AND SPRINGS
a. Install the 2 piston and springs into the cylinder body.
b. Push in the piston with a screwdriver and install the snap ring with snap ring pliers.
HINT: Tape the screwdriver tip before use.
NOTICE: Be careful not to damage the rubber lips on the pistons.
3. Except w/ TRAC: INSTALL PISTON STOPPER BOLT
Using a screwdriver, push the piston in all the way and install the piston stopper bolt and gasket.
HINT: Tape the screwdriver tip before use.
Torque: 10 Nm (100 kgf-cm, 7 ft. lbs.)