Camry Solara SLEV6 V6-3.0L (1MZ-FE) (2000)
5. CONNECT TIE ROD END TO STEERING KNUCKLE
a. Connect the tie rod end to steering knuckle.
b. Install the nut and a new cotter pin. If the holes for the cotter pin are not aligned, tighten the nut further up to 60°.
Torque: 49 Nm (500 kgf-cm, 36 ft. lbs.)
6. INSTALL DRIVE SHAFT LOCK NUT
a. While applying brakes, install the nut.
Torque: 294 Nm (3,000 kgf-cm, 217 ft. lbs.)
b. Install the lock cap and a new cotter pin. If the holes for the cotter pin are not aligned, tighten the nut further up to 60°.
7. FILL AND CHECK GEAR OIL (M/T) or ATF (A/T)
8. INSTALL FRONT FENDER APRON SEAL
9. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
10. CHECK FRONT WHEEL ALIGNMENT
11. CHECK ABS SPEED SENSOR SIGNAL
For testing and inspection of the ABS Speed Sensor Signal refer to Brakes and Traction Control; Brakes; Antilock Brake System; Wheel Speed
Sensor; Testing and Inspection; Procedures.