Camry Wagon L4-132 2164cc 2.2L DOHC (5S-FE) (1995)
NOTE:Disconnect the high-tension cords at the rubber boot. DO NOT pull on the high-tension cords. Pulling on or bending the cords may
damage the conductor inside.
7. Remove distributor.
-
Remove the two hold-down bolts, and pull out the distributor.
-
Remove the O-ring from the distributor housing.
INSTALLATION PROCEDURES
1. Set No. 1 cylinder to TDC / compression.
-
Turn the crankshaft clockwise and position the slot of the intake camshaft as shown in the illustration.
2. Install distributor
-
Install a new 0-ring to the housing.
-
Apply a light coat of engine oil on the 0-ring.