Camry Wagon L4-132 2164cc 2.2L DOHC (5S-FE) (1995)
EFI Main Relay: Testing and Inspection
1. DISCONNECT NEGATIVE (-) TERMINAL CABLE FROM BATTERY.
CAUTION: Work must not be started for at least 90 seconds from the time the ignition switch Is turned to the LOCK position and the negative
(-) terminal cable is disconnected from the battery.
2. REMOVE "EFI MAIN" RELAY.
3. INSPECT "EFI MAIN" RELAY CONTINUITY.
-
Using an ohmmeter check that there IS continuity between terminals 1 and 2.
-
Check that there is NO continuity between terminals 3 and 5.
-
If continuity is not as specified, replace the relay.
4. INSPECT "EFI MAIN" RELAY OPERATION.
-
Apply battery voltage across terminals 1 and 2.
-
Using an ohmmeter check that there is continuity between terminals 3 and 5.
-
If operation is not as specified replace the relay.
5. REINSTALL "EFI MAIN" RELAY.
6. RECONNECT NEGATIVE (-) TERMINAL CABLE TO BATTERY.