Camry Wagon L4-132 2164cc 2.2L DOHC (5S-FE) (1995)
-
Front door inside scuff plate
-
Front door opening cover
-
Cowl side trim
-
Coin box
-
Coin box bezel
-
Lower center cover
-
Lower No.2 cover
-
Lower finish panel
-
Console upper panel
-
Rear console box
-
Front console box
(a) Using a Torx wrench, loosen and lighten the 3 screws. Torx wrench: T40
(b) Disconnect and connect connector.
NOTICE: Removal and installation of the connector is done with the sensor assembly installed.
(c) Using a Torx wrench, tighten the 3 screws. Torx wrench: T40
Torque: 20 N.m (200 kgf.cm. 14 ft.lbf)
NOTICE:
-
Make sure the sensor assembly is installed to the specified torque.
-
If the sensor assembly has been dropped. or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor assembly
with a new one.
-
When installing the sensor assembly, take care that the airbag wiring does not interfere with other parts and is not pinched between other parts.
-
After installation, shake the sensor assembly to check that there is no looseness.