Removal and Installation of Steering Gear for Camry Wagon L4-132 2164cc 22L DOHC
a. Using SST 09631-22020 disconnect the tube.
7. Disconnect stabilizer bar
a. Remove the 4 bolts and 2 nuts.
NOTE: Do not remove the bar.
8. Remove PS gear assembly.
a. Remove the 2 gear assembly set bolts and nuts.
NOTE: Lift up the stabilizer bar and remove the bolts.
b. Remove the gear assembly from the LH of the vehicle.
NOTE: Do not damage the turn pressure tube.
INSTALLATION
1. Install PS gear assembly.
a. Install the gear assembly from the LH of the vehicle.
NOTE: Do not damage the turn pressure tube.
b. Torque the 2 gear assembly set bolts and nuts. Torque: 181 Nm (1,850 kgf.cm, 134 ft.lb.).
NOTE: Lift up the stabilizer bar and install the bolts.
2. Connect stabilizer bar.
a. Torque the 4 bolts and 2 nuts. Bolt: 19 Nm (195 kg.cm, 14 ft.lb) Nut: 39 Nm (400 kg.cm, 29 ft.lb.).
3. Connect pressure feed and return tubes.
a. Using SST 09631-22020 connect the tube.
b. Torque: 20 Nm (203 kgf.cm, 15 ft.lb.).
NOTE: Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).
4. Connect tube clamp.
a. Torque the nut to 10 Nm (100 kgf.cm. 7 ft.lb.).
5. Connect intermediate shaft.