Camry Wagon L4-2.0L (3S-FE) (1990)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Actuator Connectors
Actuator Brake Lines
Three Brake Actuator Hold-Down Nuts
REMOVAL
1.
Remove brake fluid from the master cylinder reservoir with a syringe or an equivalent.
CAUTION: Do not let brake fluid remain on a painted surface. Wash off immediately.
2.
Disconnect the three electrical connectors from the actuator.
3.
Using a properly sized flair nut wrench remove the six brake lines from the actuator.
4.
Remove the three nuts holding the actuator on and remove the actuator.