Camry Wagon L4-2.0L (3S-FE) (1990)
2. INSTALL DRIVEN GEAR AND DRIVE GEAR
Make sure the top of the gears are facing upward.
3. INSTALL STATOR SHAFT TO PUMP BODY
a. Align the stator shaft with each bolt hole.
b. Torque the eleven bolts.
Torque: 100 kg-cm (7 ft-lb, 10 N.m)
4. INSTALL THRUST WASHER
a. Coat the thrust washer with petroleum jelly.
b. Align the tab of the washer with the hollow of the pump body.
5. INSTALL OIL SEAL RINGS
Install the two oil seal rings to the stator shaft back side.
NOTE: Do not spread the ring ends more than necessary.