Camry Wagon L4-2.0L (3S-FE) (1990)
3. INSTALL OVERDRIVE PLANETARY RING GEAR INTO COUNTER DRIVE GEAR
While pushing down the ring gear, squeeze the snap ring end with a needle-nose pliers, and install it into the groove.
HINT: When the snap ring is fully seated, the end will be free.
4. INSTALL REAR BEARING
Using SST, press in the bearing onto the shaft.
SST 09350-32014 (09351-32120)
HINT: Press in the bearing until the side surface of the inner race touches the shaft.
5. INSTALL COUNTER DRIVE GEAR AND FRONT BEARING
a. Install the gear onto the shaft, and mesh the ring gear with the planetary pinions.
b. Place the front bearing onto the shaft.
HINT: Hold the ring gear to prevent it from falling.