Camry Wagon L4-2.0L (3S-FE) (1990)
2. SEPARATE NO.2 ONE-WAY CLUTCH AND REAR PLANETARY GEAR
3. REMOVE THRUST WASHERS
(A540E)
Remove the thrust washer from the rear side of planetary gear.
(A540H)
Remove the two thrust washers from both sides of planetary gear.
4. REMOVE NO.2 ONE-WAY CLUTCH FROM OUTER RACE
a. Remove the two snap rings and retainers from both sides.
b. Remove the No.2 one-way clutch from the outer race.
INSPECTION OF REAR PLANETARY GEAR
MEASURE PLANETARY PINION GEAR THRUST CLEARANCE
Using a feeler gauge, measure the planetary pinion gear thrust clearance.
Standard clearance: 0.16 - 0.56 mm (0.0063 - 0.0220 in)
Maximum clearance: 0.61 mm (0.0240 in.)
If the clearance is greater than the maximum, replace the planetary gear assembly.
ASSEMBLY OF NO.2 ONE-WAY CLUTCH
1. INSTALL ONE-WAY CLUTCH