Camry Wagon V6-180.5 2959cc 3.0L DOHC (3VZ-FE) (1993)
Crankshaft Main Bearing Seal: Service and Repair
REPLACEMENT OF CRANKSHAFT OIL SEALS
HINT: There are two methods (A an B) to replace the oil seal as follows:
REPLACE CRANKSHAFT FRONT OIL SEAL
A. If oil pump is removed from cylinder block:
(a) Using a screwdriver and hammer, tap out the oil seal.
(b) Using SST and a hammer, tap in a new oil seal until its surface is flush with the oil pump case edge. SST 09309-37010
(c) Apply MP grease to the oil seal lip.
B. If oil pump is installed to the cylinder block:
(a) Using a knife, cut off the oil seal lip.
(b) Using a screwdriver, pry out the oil seal.
NOTICE: Be careful not to damage the crankshaft. Tape the screwdriver tip.
(c) Apply MP grease to a new oil seal lip.