Camry Wagon V6-180.5 2959cc 3.0L DOHC (3VZ-FE) (1993)
b. Check that the valve does not leak by applying low-pressure compressed air.
2. INSPECT DISCS, PLATES AND FLANGES
Check if the sliding surfaces of the discs plates and flanges are worn or burnt. If necessary, replace them.
HINT:
-
If the lining of the disc is exfoliated or discolored, or even a part of the printed numbers are defaced, replace all discs.
-
Before assembling new discs, soak them in ATF for at least fifteen minutes.
3. CHECK DIRECT CLUTCH BUSHING
Using a dial indicator, measure the inside diameter of the two direct clutch bushings.
Maximum inside diameter: 22.13 mm (0.8713 in.)
If the inside diameter is greater than the maximum, replace the direct clutch drum.
OVERDRIVE DIRECT CLUTCH ASSEMBLY
1. INSTALL CLUTCH PISTON
a. Install new O-ring to the piston. Coat the O-ring with ATF.