Camry Wagon V6-180.5 2959cc 3.0L DOHC (3VZ-FE) (1993)
a. Install the snap ring to the ring gear.
b. While pushing down the ring gear, squeeze the snap ring end with needle-nose pliers, and instal it into the groove.
4. INSTALL REAR BEARING
Using SST, press in the bearing onto the shaft.
SST 09350 - 32014 (09351 - 32120)
HINT: Press in the bearing until the side surface of the inner race touches the planetary carrier.
5. INSTALL COUNTER DRIVE GEAR AND FRONT BEARING
a. Install the gear onto the shaft, and mesh the ring gear with the planetary pinions.
b. Place the front bearing on to the shaft.