Camry Wagon V6-180.5 2959cc 3.0L DOHC (3VZ-FE) (1993)
SST 09628-62011
5. DISCONNECT STABILIZER BAR LINK FROM LOWER ARM
-
Remove the nut and disconnect the stabilizer bar link from lower arm.
6. DISCONNECT STEERING KNUCKLE FROM LOWER BALL JOINT
-
Remove the bolt and two nuts.
-
Disconnect the steering knuckle from lower ball joint.
7. LOOSEN SIX BOLTS HOLDING DRIVE SHAFT TO DIFFERENTIAL SIDE GEAR SHAFT OR CENTER DRIVE SHAFT
-
Place match marks on the drive shaft and side gear shaft or center drive shaft.
NOTICE: Do not use a punch to mark the matchmarks. Use paint, etc.
-
Using SST, loosen the six hexagon bolts while depressing the brake pedal.
SST 09923-00020
HINT: Do not remove the bolts, finger tighten them not to drop down the drive shaft.
8. DISCONNECT DRIVE SHAFT FROM AXLE HUB
-
Using a plastic hammer, disconnect the drive shaft from the axle hub.