Camry Wagon V6-2507cc 2.5L DOHC (2VZ-FE) (1988)
Thermostat: Service and Repair
REMOVAL OF THERMOSTAT
1. DRAIN ENGINE COOLANT
2. REMOVE WATER INLET PIPE
-
Disconnect lower radiator hose from water inlet pipe.
-
Remove timing belt from water pump pulley.
-
Remove the bolt holding the water inlet pipe to the alternator belt adjusting bar.
-
Remove the water inlet pipe and o-ring.
3. DISCONNECT WATER TEMPERATURE SENSOR CONNECTOR
The Water Temperature Switch (for Cooling Fans) Is Located On The Water Inlet
4. REMOVE WATER INLET
-
Remove the three nuts and water inlet from the water pump.
5. REMOVE THERMOSTAT AND GASKET
INSPECTION OF THERMOSTAT
INSPECT THERMOSTAT
HINT: The thermostat is numbered with the valve opening temperature.
(a) Immerse the thermostat in water and gradually heat the water.
(b) Check the valve opening temperature
Valve opening temperature: 80 - 84°C (176 - 183°F)
-
If the valve opening temperature is not as specified, replace the thermostat.
(c) Check the valve lift.
Valve lift: 8.5 mm (0.335 in.) or more at 95°C (203°F)
-
If the valve lift is less than specification, replace the thermostat.