Camry Wagon V6-2507cc 2.5L DOHC (2VZ-FE) (1988)
9. SLIGHTLY JACK UP ENGINE
Raise the engine enough to remove the weight from the engine mounting on the right side.
10. REMOVE ENGINE RH MOUNTING INSULATOR
a. (w/ A.B.S.)
Remove the clamp bolts of the PS oil cooler pipes.
b. Remove the bolt, four nuts and mounting insulator.
11. REMOVE SPARK PLUGS
12. REMOVE NO.2 TIMING BELT COVER
Remove the eight bolts, timing belt cover and gasket.
13. REMOVE ENGINE RH MOUNTING BRACKET
Remove the three bolts and mounting bracket.
14. IF REUSING TIMING BELT, CHECK INSTALLATION MARKS ON TIMING BELT
Check that there are four installation marks on the timing belt by turning the crankshaft pulley as shown in the illustration.
If the installation marks have disappeared, place a new installation mark on the timing belt before' removing each part.
15. SET NO.1 CYLINDER TO TDC/COMPRESSION