Camry Wagon V6-2507cc 2.5L DOHC (2VZ-FE) (1988)
Axle Shaft: Service and Repair
Driveshaft, Replace
Fig. 9 Driveshaft & related components. 1988 Camry w/V6 engine
REMOVAL
1.
Remove cotter pin, locknut cap and locknut.
2.
Remove engine under covers.
3.
Disconnect tie rod and steering knuckle from lower arm.
4.
Loosen attaching bolts securing driveshaft to the differential side gear or center driveshaft assembly, Fig. 9.
5.
Remove driveshaft as follows:
a. Remove left hand driveshaft by loosening attaching bolts and pulling out driveshaft. When removing the left hand driveshaft, do not compress
the inboard boot.
b. Remove joint end cover gasket from driveshaft.