Testing and Inspection for Camry XLE Sedan Power Seat Motor
Power Seat Motor: Testing and Inspection
INSPECT SLIDE MOTOR OPERATION
a. Connect the positive (+) lead from the battery to terminal 2 and the negative (-) lead to terminal 1, check that the motor turns counterclockwise.
b. Reverse the polarity, check that the motor turns clockwise.
If operation is not as specified, replace the seat adjuster.
INSPECT SLIDE MOTOR PTC THERMISTOR OPERATION
a. Connect the positive (+) lead from the battery to terminal 1 the positive (+) lead from the ammeter to terminal 2 and the negative (-) lead to the
battery negative (-) terminal, then move the seat cushion to the front position.
b. Continue to apply voltage, check that the current changes to less than 1 ampere within 4 to 90 seconds.
c. Disconnect the leads from terminals.
d. Approximately 60 seconds later, connect the positive (+) lead from the battery to terminal 2 and the negative (-) lead to terminal 1, check that the
seat cushion begins to move backwards.
If operation is not as specified, replace the seat adjuster.