Camry XLE Sedan L4-2164cc 2.2L DOHC (5S-FE) MFI (1999)
Brake Master Cylinder: Service and Repair
Disassembly and Reassembly
DISASSEMBLY
1. REMOVE RESERVOIR
a. Remove the set screw and pull out the reservoir.
Torque: 1.7 Nm (18 kgf-cm, 16 inch lbs.)
b. Remove the cap and strainer from the reservoir.
2. REMOVE 2 GROMMETS
3. Except w/TRAC:
PLACE CYLINDER IN VISE
4. w/o TRAC:
REMOVE PISTON STOPPER BOLT
Using a screwdriver, push the pistons in all the way and remove the piston stopper bolt and gasket.
HINT: Tape the screwdriver tip before use.
Torque: 10 Nm (100 kgf-cm, 7 ft. lbs.)
5. w/o TRAC:
REMOVE 2 PISTONS AND SPRINGS
a. Push in the piston with a screwdriver and remove the snap ring with snap ring pliers.
HINT: Tape the screwdriver tip before use.
b. Remove the No. 1 piston and spring by hand, pulling straight out, not at an angle.
NOTICE:
-
If pulled out and installed at an angle, there is a possibility that the cylinder bore could be damaged.
-
At the time of reassembly, please refer to the following item:
Be careful not to damage the rubber lips on the pistons.
c. Place a rag and 2 wooden blocks on the work table, and lightly tap the cylinder flange against the block edges until the No. 2 piston drops out
of the cylinder.