Camry XLE Sedan L4-2164cc 2.2L DOHC (5S-FE) MFI (1999)
Spark Plug: Testing and Inspection
INSPECT SPARK PLUGS
NOTE:
-
Never use a wire brush for cleaning.
-
Never attempt to adjust the electrode gap on a used spark plug.
-
Spark plugs should be replaced every 100,000 km (60,000 miles).
a. Disconnect the high-tension cords from the spark plugs.
b. Inspect the electrode.
Using a megger (insulation resistance meter), measure the insulation resistance.
Standard correct insulation resistance: 10 M Ohms or more
If the resistance is less than specified, proceed to step (d).
HINT: If a megger is not available, the following simple method of inspection provides fairly accurate results.
Simple Method:
-
Quickly race the engine to 4,000 rpm 5 times.
-
Remove the spark plug. (See step (c))
-
Visually check the spark plug.
-
If the electrode is dry ... OK
-
If the electrode is wet ... Proceed to step (d)
-
Reinstall the spark plug. (See step (g))
c. Using a 16 mm plug wrench, remove the 4 spark plugs.
d. Visually check the spark plug for thread damage and insulator damage.
If abnormal, replace the spark plug.
Recommended spark plug:
DENSO made - PK20TR11