Camry XLE Sedan L4-2164cc 2.2L DOHC (5S-FE) MFI (1999)
-
If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor
assembly with a new one.
-
When installing the sensor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other
parts.
-
After installation, shake the sensor assembly to check that there is no looseness.
2. INSTALL FRONT SEAT OUTER BELT RETRACTOR
a. Install the retractor with the 2 bolts.
Torque:
Upper bolt: 7.5 Nm (76 kgf.cm, 66 in.lbf)
Lower bolt: 42 Nm (430 kgf.cm, 31 ft.lbf)
b. Connect the pretensioner connector.
3. INSTALL CENTER PILLAR LOWER GARNISH
4. INSTALL FRONT DOOR SCUFF PLATE