Camry XLE Sedan L4-2164cc 2.2L DOHC (5S-FE) MFI (1999)
3. REMOVE FRONT SEAT OUTER BELT RETRACTOR
a. Disconnect the pretensioner connector.
b. Remove the 2 bolts and retractor.
4. REMOVE SIDE AIRBAG SENSOR ASSEMBLY
a. Disconnect the side airbag sensor assembly connector.
NOTE: Disconnect the connector with the sensor assembly installed.
b. Using a torx wrench remove the 3 screws and side airbag sensor assembly.
Torx wrench: T40 (Part No.09042-00020 or locally manufactured tool)
Installation
NOTE:
-
Never use SRS parts from another vehicle. When replacing parts, replace them with new ones.
-
Never reuse the side airbag sensor assembly involved in a collision when the airbag has deployed.
-
Never repair a sensor in order to reuse it.
1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY
a. Using a torx wrench, install the side airbag sensor assembly with the 3 screws.
Torx wrench: T40 (Part No.09042-00020 or locally manufactured tool)
Torque: 20 Nm (205 kgf.cm, 15 ft.lbf)
b. Connect the side airbag sensor assembly connector.
NOTE:
-
Connection of the connector is done after the sensor assembly has been installed. Make sure the sensor assembly is installed with the
specified torque.