Camry XLE Sedan L4-2164cc 2.2L DOHC (5S-FE) MFI (1999)
NOTICE: When using a vise, do not overtighten it.
1. COAT WITH POWER STEERING FLUID
2. INSTALL VANE PUMP SHAFT
3. INSTALL STRAIGHT PINS
Using a plastic hammer, tap in 2 new pins.
NOTICE: Be careful not to damage the pins.
4. INSTALL CAM RING
Align the holes of the ring and 2 straight pins, and install the ring with the inscribed mark facing outward.
5. INSTALL VANE PUMP ROTOR
a. Install the rotor with the inscribed mark facing outward.
b. Install a new snap ring to the vane pump shaft.
6. INSTALL VANE PLATES
Install the 10 plates with the round end facing outward.
7. INSTALL GASKET
Install a new gasket.
8. INSTALL SIDE PLATE
Align the holes of the plate and 2 straight pins.
9. INSTALL WAVE WASHER
Install the washer so that its protrusions fit into the slots in the side plate.
10. INSTALL REAR HOUSING
a. Coat 2 new O-rings with power steering fluid and install them to the housing.
b. Torque the 4 bolts.
5S-FE and 1MZ-FE Engines:
Torque: 24 Nm (240 kgf-cm, 17 ft. lbs.)